Main Gear
1) Check to see if the Main Gear (F) has slipped on the main shaft.
- If it has slipped, press it back into position.
Tail
1) Check and make sure the tail prop (O) has not flattened.
-If flattened, twist the rotor blade back into position or replace.
2) Make sure the Vertical Fin (Q) has not twisted into the tail prop.
Rotor Head
(Refer to illustration on previous page)
1) Check the feathering spindle to ensure it is not bent and the feathering spindle bolts are
tight.
2) Check the Blades for cracks or chips.
- If using the Fast Flight Main Blades, check the counterweight to ensure it is still
in the blade.
Any Questions about this product should be directed
to Horizon Hobby’s Product Support department.
Horizon Hobby, Inc.
ATTN: Product Support
4105 Fieldstone Road
Champaign, IL 61822
Email: productsupport@horizonhobby.com
Support Phone: (877) 504-0233
Fax: (217) 355-1552
© 2011 Horizon Hobby, Inc.
Blade is a registered trademark of Horizon Hobby, Inc.
Created 03/2011 33117
To Next Page
Loading...
Need help?
General
