EN
UMX Timber X BNF
8
Control Surface Direction
Switch on the transmitter and connect the
battery. Use the transmitter to operate the
aileron, elevator, and rudder controls. View the
aircraft from the rear when checking the control
directions.
NOTICE: Bind the aircraft and transmitter
before performing these tests. Move the
transmitter controls to make sure the aircraft
control surfaces move correctly and in the
proper direction. Make sure the tail linkages
move freely.
Ailerons
1. Move the aileron stick to the left. The left
aileron should move up and the right aileron
should move down, which will cause the
aircraft to bank left.
2. Move the aileron stick to the right. The right
aileron should move up and the left aileron
down, which will cause the aircraft to bank
right.
Elevators
3. Pull the elevator stick back. The elevator
should move up, which will cause the aircraft
to pitch up.
4. Push the elevator stick forward. The elevator
should move down, which will cause the
aircraft to pitch down.
Rudder
5. Move the rudder stick to the left. The rudder
should move to the left, which will cause the
aircraft to yaw left.
6. Move the rudder stick to the right. The
rudder should move to the right, which will
cause the aircraft to yaw right.
Transmitter
Command
Control Surface
Response
Aileron StickElevator Stick
Rudder Stick
To Next Page
Loading...
Need help?
General
