32
TR10A108-B RE / 02.2013
6.1.3 Menu 11 – 13: Register hand
transmitter
A maximum of 150 radio codes can be
transferred and distributed to the
available channels. If more than
150 radio codes are transferred, the first
one will be deleted. If the radio code of a
hand transmitter button is transferred for
two different functions, the radio code
for the first transferred function will be
deleted.
The following prerequisites must be
fulfilled in order to transfer a radio code
to the integrated radio receiver:
The operator is idling.ō
The warning or hold-open phase is ō
not active.
Menu 11: Transfer radio code for
impulse control:
See Figure
▶
24
Menu 12: Transfer radio code for
the operator light:
See Figure
▶
25
Menu 13: Transfer radio code for
partial opening:
See Figure
▶
26
NOTE:
Please see section 8.4 for more
information on the hand transmitter.
To cancel hand transmitter
registration:
Press the
▶
PRG button.
Timeout
If the timeout elapses (25 seconds) while
registering the hand transmitter, the
operator will automatically switch back
to programming mode.
ENGLISH
To Next Page
Loading...