HOTA F6+ - Page 13

Standby
Name 00:00:00
CH1
Standby
00:00:00
CH2
0 mAh
22.84 V
0.0A 0W
3.829V
3.833V
1
4
3.838V
3.835V
2
5
3.836V
3.839V
3
6
09
F6+ 4-Channel DC Smart Charger
Operation and Setup
Working parameters Display
Standby
Operation
Time
Operation
time
Capacity
charged
Task status
Output
Current
Output
Power
Total Battery
Voltage
Cell Voltage
Device Name
Current
channel
Current
channel
Standby State : Simple Operation
1.Connect power supply to the AC or DC port of the charger, wait for the system to complete the
self-checking. connect the battery to the charger in the standby interface;
2. In the standby state, the screen is in blue color .At that time, the output current, total battery voltage
,capacity completed and operation time are all shown as zero .
Press △ key or ▽ key during operation can switch the display information in the lower half of the screen, which are
cell voltage and run data.
3. Short press OK key to pop up the “Task Settings” menu, adjust task parameters，
Short press OK key to start the task.
4. Short press CH key display the channel you choose;
5. Long press OK key to enter the “Charger Settings”.