11
Button Selection:
To select an option, press the button and you will see a light come on alongside the button.
Press again to cancel, and the light will go out.
Display Error Message
The display will show an message in the display if there is one of the following problems:
H20 A problem with the water supply. Check the taps are turned on and working.
door Please close the door properly.
F000 This indicates a machine fault - this is an Error Code.
The 'F' number will vary depending on the fault. Refer to Error Codes.
Options are selected by pressing the button and confirmed by illumination of the LED.
Drying High Heat
The original default setting was LOW heat. By selecting this allows HIGH heat for tumble drying.
From Serial Number 60612.0000 (Date Code 54), the Eeprom file settings changed. The default
setting is now HIGH heat and will be indicated on the option LED. If High heat is not required this
option must be deselected.
Reduced Creases
Changes wash action and slightly increases drum speed on cotton programmes and removes end
of wash spin with a reduced speed on final spin on synthetic programmes.
Available on programmes C, E, G, and Rinse and Spin programmes.
Rinse Hold
Clothes will be suspended in cold water at the end of the final rinse. To complete the programme,
press the button when the LED is flashing.
This option is not available on programmes A, H, L and Spin only.
Time Saver
Saves programme time by up to a third depending on programme selected and is achieved by
reducing wash run times.
This option is only available on programmes B, D, G and H.
Time Delay
This option can delay the start of your wash programme by up to 24 hours.
The display will show the delay you have chosen.
Each press of the option button will add a delay of one hour. If you press after 24 shows on the
display the machine will reset the time delay and show 'OFF' in the display, any press after this will
start counting again from one hour.
Variable Wash Temperature Control - Selected by Push Button
Enables a lower wash temperature and No Heat to be selected by pressing the button.
Note: The display defaults to the maximum temperature for the programme selected.
Variable Tumble Drying Time
Enables the required drying time to be chosen.
To Next Page
Loading...
Need help?
General
