5
EN
Anti-flooding protection*
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the
water supply in the event of anomalies or leaks from
inside the appliance.
- is provided with a Water Stop
* safety device, in
other words it has a water inlet hose that consists of
a transparent hose on the outside and a red hose on
the inside: both the hoses can withstand extremely
high pressure. If the internal hose breaks, the
external hose becomes a bright red colour and
carries the water instead, thus avoiding any leakage.
It is very important to check the external hose
regularly: if it is a bright red colour, it must be
replaced by an authorised technician as soon as
possible (see Assistance).
WARNING: HAZARDOUS VOLTAGE!
Under no circumstance should the water inlet hose
be cut as it contains live electrical parts.
The Company shall not be held responsible for
any incidents that occur if these regulations are not
observed.
* Only available in selected models.
Sink Waste System
For under sink drainage:
before connecting the drain hose, remove any
internal restrictions; this will prevent a build up of
debris which could cause a blockage
remove any restrictions from the waste spigot and
ensure that the sealing bung is removed
the hose should be routed, such that it is raised
to a minimum height of 800mm (31/2).
Ensure the sink outlet pipe has a minimum
diamtere of 32mm.
Untie the end of the
GREY drainage hose from
the rear of the appliance.
Reposition the Hooked
End Support as required
along the GREY drainage
hose.
If fitting an under sink waste disposal unit, cut out
the membrane, bung or blanking plug.
Ensure the drain hose is securely attached, to
prevent it coming away while the machine is in
use and causing a flood.
To Next Page
Loading...
