CARE AND CL
E4NING
(continued)
How to Ilernove the storage Drawer or Kick panel to clean Under the Range
The area under the range can be reached easily for
To clean under models with a
cleaning by removing the botiom drawer (on some
front kick panel, remove the
modeis). To remove, puIl the drawer out all the way,
panel by pulling it straight out
tilt up the front and remove it. To replace, insert glides
at the bottom. To replace the
at the back of the drawer beyond the stop on range
panel, first hook the top tabs on
glides. Lift the drawer if necessary to insert easily. Let
and then the bottom tabs.
.
the front of the drawer down, then push in to close.
Control Panel and Knobs
Clean up any spills or spatters with a damp cloth.
The control knobs may be removed for easier cleaning.
Remove heavier soil with warm, soapy water.
To remove a knob, pull it straight off the stem. Wash
Clean the control panel with mild liquid
the knobs in soap and water but do
not soak.
dish detergent and a soft cloth. Rub tie control
.
~.—————
panel lightly.
CAUTION: Do not use abrasives of any kind on the
control panel. The lettering on models with touch
pads is sensitive to abrasives and pressure.
Oven Vent
I
The oven is vented through an opening under the right rear surface unit.
Never cover the opening with aluminum foil or any other material. This
would prevent the oven vent from working properly.
Painted Surfaces
Painted surfaces include the outside oven door, sides,
Do not use commercial oven cIeaners, cleansing
control panel and drawer front. Clean these with soap
powders, steel wool or harsh abrasives on any
and water or a vinegar and water solution.
painted surface.
Glass Window (on some models) and Glass Surfaces
To clean the outside glass window (on some
models) and glass surfaces, use a glass cleaner.
Rinse and polish with a dry cloth.
Metal Parts
Do not use steel wool, abrasive%ammonia or
commercial oven cleaners. To safely clean surfaces;
wash, rinse and then dry with a soft cloth.
Ij
f
●
26
To Next Page
Loading...
