EasyManua.ls Logo

HotSpring Grandee - User Manual

HotSpring Grandee
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
x Page x x
Pre-Delivery Instructions
Please take the time to read this booklet carefully, as it will provide you with the information you will need to ensure
the safe, secure, and timely installation of your new spa. The following sections are guidelines on how to prepare for
delivery and set-up of your new spa. Specifically covered are site selection, delivery access, ground preparation, and
electrical requirements.
Remember to carefully review the Owner’s Manual that accompanies your spa, and to register the spa's warranty
within 10 days of delivery. These items, along with other valuable information, will be found in the Owner’s Package
which has been placed in the equipment compartment of your spa, where you will also find its serial number.
Watkins Manufacturing Corporation reserves the right to change features, specifications and design without
notification and without incurring any obligation.
DATE PURCHASED: _________________________________________________________________
DATE INSTALLED: ___________________________________________________________________
DEALER: ___________________________________________________________________________
ADDRESS: __________________________________________________________________________
TELEPHONE: _______________________________________________________________________
In most cities and counties, permits will be required for the installation of electrical circuits or the construction of
exterior surfaces (decks and gazebos). In addition, some communities have adopted residential barrier codes which
may require fencing and/or self-closing gates on the property to prevent unsupervised access to a pool (or spa) by
children under 5 years of age. Your HOT SPRING spa is equipped with a locking cover that meets the ASTM F1346-
91 Standard for Safety Covers and as a result, is usually exempt from most barrier requirements. As a general
practice, your local Building Department will inform you of any applicable barrier requirements at the time a permit is
obtained for the installation of an electrical circuit. Your Hot Spring dealer can provide information on which permits
may be required.
Hot Spring Spa Pre-Delivery Instructions
Congratulations on your decision to enjoy the finest spa available...
Welcome to the growing family of HOT SPRING spa owners.
HIGHLIFE
®
COLLECTION
Register your warranty
using the QR code below:

Other manuals for HotSpring Grandee

Questions and Answers

  • B
    bcarrollSep 14, 2025
    Why is the water cloudy in my HotSpring Grandee?
    • D
      David HoltSep 14, 2025
      Cloudy water in your HotSpring Hot Tub can result from several factors. It could be due to dirty filters, so cleaning them is a good first step. Excessive oils or organic matter might be present; in this case, shock the spa with sanitizer. Improper sanitization itself can cause cloudiness, so ensure you're adding enough sanitizer. Suspended particles or organic matter could also be the culprit; adjust the pH and/or alkalinity to the recommended range. Finally, consider whether the water is overused or old, which would necessitate draining and refilling the spa.
  • D
    Dustin MitchellSep 13, 2025
    How to remove scale from my HotSpring Grandee Hot Tub?
    • S
      shawamandaSep 14, 2025
      Scale in your HotSpring Hot Tub is caused by high calcium content in the water, and total alkalinity and pH being too high. Adjust the total alkalinity and pH. If scale requires removal, drain the spa, scrub off the scale, refill the spa, and balance the water.
  • D
    douglas82Sep 12, 2025
    What to do if my Moto-Massage® jet is inoperative in my HotSpring Grandee Hot Tub?
    • K
      Kiara CoxSep 12, 2025
      If the Moto-Massage® jet in your HotSpring Hot Tub is inoperative or erratic, it could be due to closed Comfort Control valves or clogged filters. To resolve this, open the Comfort Control levers and clean the filters.
  • M
    Maria CruzAug 25, 2025
    What to do if my HotSpring Grandee is not heating up, but the jets and light are working?
    • M
      Michael PaceAug 25, 2025
      If your HotSpring Hot Tub isn't heating up, but the jets and light are working, with the Green logo "Ready" and Blue logo "Power" indicators blinking, it could be due to an open integrated pressure switch or a tripped circulation pump thermal cut-off. Here’s what you should do: * Check for clogged filters. The integrated pressure switch will reset when the flow of water through the heater has been restored. Call for service if the heater trips frequently. * Check for clogged filters or air locks in plumbing. Disconnect power to the spa and allow the circulation pump to cool. The circulation pump thermal cut-off will reset when the pump has cooled and power is reapplied. Call for service if the circulation pump thermal cut-off trips frequently.
  • A
    Andrew SandersSep 10, 2025
    What to do if my HotSpring Grandee water is causing skin irritation or rash?
    • C
      crystal45Sep 10, 2025
      If you're experiencing skin irritation or a rash from your HotSpring Hot Tub water, it could be due to unsanitary water or a free chlorine level above 5 ppm. Shock the spa with sanitizer and maintain the sanitizer level. Also, allow the free chlorine level to drop below 5 ppm before using the spa.
  • D
    dpalmerSep 9, 2025
    How to fix organic buildup around my HotSpring Grandee Hot Tub?
    • D
      Darrell HicksSep 9, 2025
      Organic buildup or a scum ring around your HotSpring Hot Tub is caused by a build-up of oils and dirt. Wipe off the scum with a clean rag. If it's severe, drain the spa, use a spa surface and tile cleaner to remove the scum, and refill the spa.
  • A
    Alexander AndersonSep 8, 2025
    What to do if my HotSpring Hot Tub water is causing eye irritation?
    • J
      jmathewsSep 8, 2025
      If you're experiencing eye irritation from your HotSpring Hot Tub water, it could be due to low pH or low sanitizer levels. Adjust the pH, and shock the spa with sanitizer and maintain the sanitizer level.
  • D
    Daniel TaylorSep 7, 2025
    What to do if my HotSpring Grandee Hot Tub water smells musty?
    • K
      Kayla LittleSep 7, 2025
      If your HotSpring Hot Tub has a musty odor, it's likely due to bacteria or algae growth. Shock the spa with sanitizer. If the problem is visible or persistent, drain, clean, and refill the spa.
  • J
    Jody WestSep 5, 2025
    What to do if my HotSpring Grandee Hot Tub light is inoperative?
    • J
      Joshua KennedySep 5, 2025
      If the light in your HotSpring Hot Tub is inoperative, it could be due to the spa lock being activated or a faulty light wiring or assembly. To resolve this, deactivate the spa lock or replace the light assembly.
  • M
    milleryolandaSep 4, 2025
    Why is the Blue Logo "Power" indicator blinking on my HotSpring Grandee Hot Tub?
    • L
      Lori BartlettSep 4, 2025
      If the Blue Logo "Power" indicator is blinking on your HotSpring Hot Tub, it means the heater high-limit thermostat has tripped. To fix this, disconnect power for at least thirty seconds to reset the heater high limit. If it won't reset, check for clogged filters. If tripping continues, call for service.

HotSpring Grandee Specifications

General IconGeneral
Seating Capacity7 adults
Jet Count43
Electrical Requirements240v/50 amp
PumpWavemaster® 9000
Filtration SystemTri-X filters
Control SystemIQ 2020® with wireless remote
LightingMulti-color LED lighting
Warranty5-Year Shell Structure, 3-Year Shell Surface, 2-Year Plumbing, 5-Year No-Leak Plumbing, 5-Year Equipment, 5-Year Heater

Related product manuals