Page 2
Safety Information
IMPORTANT: Failure to wait 30 seconds before resetting the GFCI
may cause the spa’s Power Indicator (on the control panel) to blink. If
this occurs, repeat the GFCI test procedure.
DANGER - RISK OF ELECTRICAL SHOCK
• Install at least 5 feet (1.5 m) from all metal surfaces. A spa may
be installed within 5 feet of a metal surface if each metal surface is
permanently connected by a minimum No. 8 AWG (8.4 mm
²
) solid
copper conductor attached to the wire ground connector on the
terminal box that is provided for this purpose if in accordance with
National Electrical Code ANSI/NMFPA70-1993.
• Do not permit any electrical appliances, such as a light, telephone,
radio, or television within 5 feet (1.5 m) of a spa. Failure to maintain
a safe distance may result in death, or serious personal injury due to
electrocution, if the appliance should fall into the spa.
• Install your spa is such a way that drainage is away from the electrical
compartment and from all electrical components.
DO:
• Be sure your spa is connected to the power supply correctly - use a
licensed electrical contractor.
• Disconnect the spa from the power supply before draining the spa or
servicing the electrical components.
• Test the Ground Fault Circuit Interrupter(s) before each use.
• Replace audio components only with identical components (if your
spa is equipped with an audio component).
DON'T:
• Use the spa with the equipment compartment door removed.
• Place electrical appliances within 5 feet (1.5m) of the spa.
• Use an extension cord to connect the spa to its power source. The
cord may not be properly grounded and the connection is a shock
hazard. An extension cord may cause a voltage drop, which will
cause overheating of the jet pump motor and motor damage.
• Attempt to open the electrical control box. There are no user serviceable
parts inside.
• Leave audio compartment door open (if your spa is equipped with an
audio component).
RISKS TO AVOID
DANGER - RISK OF INJURY
• To reduce the risk of injury to persons, DO NOT remove suction
fittings (filter standpipes) located in the filter compartment.
• The suction fittings in the spa are sized to match the specific water
flow created by the pump. Never replace a suction fitting with one
rated less than the flow rate marked on the original suction fitting.
• There is a danger of slipping and falling. Remember that wet surfaces
can be very slippery. Take care when entering or exiting the spa.
• Never operate spa if the suction fittings are broken or missing.
• People with infectious diseases should not use the spa.
• Keep any loose articles of clothing, long hair, or hanging jewelry away
from rotating jets or other moving components.
INCREASED SIDE EFFECTS OF MEDICATION
• The use of drugs, alcohol may cause unconsciousness with the
possibility of drowning.
• Persons using medications should consult a physician before using
a spa; some medication may cause a user to become drowsy, while
other medication may affect heart rate, blood pressure, and circulation.
• Persons taking medications which induce drowsiness, such as
tranquilizers, antihistamines, or anticoagulants should not use the spa.
HEALTH PROBLEMS AFFECTED BY SPA USE
• Pregnant women should consult a physician before using spa.
• Persons suffering from obesity, or with a medical history of heart
disease, low or high blood pressure, circulatory system problems, or
diabetes should consult a physician before using spa.
UNCLEAN WATER
• Keep the water clean and sanitized with correct chemical care. The
recommended levels for your Hot Spring
®
spa are:
Free Available Chlorine:
3.0-5.0 ppm
Total Alkalinity:
40-120 ppm
Water pH:
7.2-7.6
Calcium Hardness:
50-150 ppm
• Refer to Water Quality and Maintenance section for complete
instructions.
IMPORTANT: Turn on the jet pump for a least ten minutes after adding
ANY spa water chemicals into the filter compartment.
Clean the filter cartridges monthly to remove debris and mineral buildup
which may affect the performance of the hydromassage jets, limit the
flow, or trip the high limit thermostat, which will turn off the entire spa.
AVOIDING THE RISK OF HYPERTHERMIA
Prolonged immersion in hot water can result in HYPERTHERMIA, a
dangerous condition which occurs when the internal temperature of
the body reaches a level above normal 98.6°F (37°C). The symptoms
of hyperthermia include unawareness of impending hazard, failure to
perceive heat, failure to recognize the need to exit the spa, physical
inability to exit the spa, fetal damage in pregnant women, and
unconsciousness resulting in a danger of drowning.
WARNING
The use of alcohol, drugs, or medication can greatly increase the risk of
fatal hyperthermia in hot tubs and spas.
To Next Page
Loading...
Need help?
General