Hotsy 1800 Series User Manual (English)

Other manuals for Hotsy 1800 Series

Questions and Answers:

E
elizabethgrahamSep 7, 2025
What to do if my Hotsy Burner pressure washer runs but won't spray?
- C
  cdeckerSep 7, 2025
  If your Hotsy Burner pressure washer runs but won't spray, consider these potential causes: * The trigger of the trigger gun may be released. Squeeze the trigger. * The water supply might not be turned on. Open the water supply valve. * The pressure nozzle could be clogged. Clean the pressure nozzle opening. * The inlet water screen might be clogged. Check the screen and clean it if necessary. * The pump could be sucking air. Fill the detergent container and check for loose hose clamps or fittings.
R
Robert BrewerSep 9, 2025
Why is there low spray pressure at the nozzle of my Hotsy Burner?
- P
  peter21Sep 9, 2025
  To address low spray pressure at the nozzle of your Hotsy Burner pressure washer: * Ensure you have an adequate water supply by fully opening the faucet. Check for any kinks or damage to the hose. Use a 5/8" minimum hose. Also, inspect the inlet screen for any debris that may be causing a clog. * The pressure nozzle might be partially clogged or damaged. Clean or replace the nozzle. * Air could be entering through the detergent inlet line. Refill the detergent container and make sure the pick-up screen is fully immersed.
P
Pamela HobbsSep 12, 2025
How to fix a Hotsy Burner pressure washer that won't produce hot water?
- J
  jerry73Sep 12, 2025
  If your Hotsy Burner pressure washer will not produce hot water, check the following: * Ensure the burner switch is in the ON position. * Verify the gas valve switch is in the ON position. * Check that there is an adequate fuel supply. * The pump must be running before the burner will light, so ensure the pump switch is turned on.
R
robert67Sep 12, 2025
Why is there poor or no detergent flow in my Hotsy Burner?
- B
  Brady DeanSep 13, 2025
  If you're experiencing poor or no detergent flow with your Hotsy Burner, consider these solutions: * Ensure an adequate detergent supply by refilling the detergent container. Make sure the pick-up screen is fully immersed and that the detergent container is at or above the level of the pump. * Check for a clogged detergent screen or hose and clean it. Always start with a clean detergent container. * Inspect the detergent injector check valve for clogs and clean it.
F
frankmarkSep 14, 2025
What causes the unloader to cycle when the trigger gun is opened or closed on my Hotsy Burner?
- M
  Melissa GarciaSep 14, 2025
  If the unloader cycles when the trigger gun is opened or closed on your Hotsy Burner, here's what to check: * There may be air in the system. Open and close the trigger gun several times to bleed out any air. * The unloader itself could be defective and may need replacement. * Check for water leaks between the unloader valve and the trigger gun. Inspect fittings, the hose, and the trigger gun for leaks, and repair or replace any faulty components.