Hotsy 560SS User Manual

9.808-383.0 - A (10/23)
MODEL:
SERIAL NUMBER:
DATE PURCHASED:
FOR SALES AND SERVICE, PLEASE CONTACT:
OPERATING INSTRUCTIONS
AND PARTS MANUAL
Read instructions carefully before attempting to assemble, install, operate or service this pressure
washer. Failure to comply with instructions could result in personal injury and/or property damage!
MODELS 555HE, 555SS,
560SS, 680SS

Hotsy 560SS Specifications

General

Model	560SS
Category	Pressure Washer
Pressure	3000 PSI
Flow Rate	4 GPM
Engine	Honda GX390
HP	13 HP
Thermal Relief Valve	Yes
Hose Length	50 ft
Nozzle Included	Yes
Weight	350 lbs
Power Source	Gasoline
Pump	Triplex Plunger Pump

Summary

Introduction and Safety Information

Owner/User Responsibility & Electrical Safety

Outlines user responsibilities and details electrical safety requirements like grounding and GFCI.

Fire, Explosion, and Fuel Hazards

Warns about flammable liquids, ignition sources, and safe fueling practices.

High-Pressure Spray & Operational Hazards

Covers risks from high-pressure streams, noise, thermal issues, and handling.

Stability, Environment & Operator Condition

Addresses safe operation on unstable surfaces and the impact of operator fatigue or substances.

Component Identification

Assembly Instructions

Unpacking and Parts Check

Instructions for safely unpacking the pressure washer and checking for missing components or damage.

Hose, Gun, and Wand Assembly

Guidance on installing the pressure hose, trigger gun, and wand assembly.

Handle Installation

Steps for attaching the handle to the pressure washer chassis.

Installation Instructions

Getting Started and Placement

Importance of proper installation for performance, service life, and maintenance cost.

Venting Requirements

Guidelines on proper venting of exhaust gases according to local and federal regulations.

Burner Air Adjustment

Procedures for adjusting burner air for optimal performance at different altitudes and conditions.

Operation Procedures

Pre-Operation Checks & Electrical Setup

Covers pre-start inspections, electrical connections, and GFCI testing.

Nozzle Installation

Guidance on selecting and installing the correct pressure nozzle for cleaning tasks.

Starting and Stopping the Machine

Step-by-step procedures for starting, operating, and safely shutting down the pressure washer.

Cleaning and Storage

Cleaning Techniques and Recommendations

Methods for pre-rinsing, applying detergent, and rinsing surfaces for effective cleaning.

Storage Instructions

Instructions for protecting the machine from freezing by storing in a heated area or using antifreeze.

Maintenance Procedures

Pump and Motor Maintenance

Covers pump lubrication, proper care, and annual motor oiling schedule.

Valve and Filter Maintenance

Details care for relief and unloader valves, and burner fuel filter.

Heating Coil Care

Information on descaling and desooting the heating coil to maintain performance.

Troubleshooting Guide

Motor and Water Spray Issues

Addresses pump motor failure, no water spray, and low pressure from the nozzle.

Detergent and Burner Ignition Problems

Covers poor detergent flow and issues with the burner not igniting.

Burner Smoke and Odor Issues

Details causes and solutions for machine smoke and obnoxious odors during operation.