The Hover-1 ALL-STAR 2.0 Electric Scooter is a personal transporter designed for safe and enjoyable riding. This manual provides comprehensive instructions for its operation, maintenance, and safety precautions.
Function Description
The ALL-STAR 2.0 utilizes digital gyroscopes and acceleration sensors to control balance and motion, responding to the user's center of gravity. A built-in inertia dynamic stabilization system assists with balance when moving forward and backward, though not during turns. The scooter is equipped with powerful built-in wireless speakers, allowing users to stream music while riding. It features a battery indicator to show charge status and a running indicator that lights up when the system is active.
Usage Features
Before riding, it is crucial to thoroughly read and understand all instructions, warnings, and safety features in this manual. Always wear a properly fitted helmet that complies with CPSC or CE safety standards.
Turning On/Off: To power on, place the ALL-STAR 2.0 flat on the floor and press the power button located on the rear. The LED indicator in the center will light up, confirming it's on. To power off, press the power button once.
Mat Sensors: The scooter has four sensors under the foot mats. When riding, ensure your feet are placed firmly on these mats. Applying weight and pressure to only one foot mat may cause the ALL-STAR 2.0 to vibrate or spin in one direction.
Battery Indicator: A green LED light indicates a full charge, a red flashing LED with beeping signifies a low battery, and a yellow light means the board is charging. Recharge the ALL-STAR 2.0 when the LED light turns red.
Running Indicator: This LED lights up when the foot mats are triggered, indicating the system is in a running state. If an error occurs, the running LED will turn red, and a beep sound will alert the user to take precautions.
Riding the ALL-STAR 2.0:
- Initial Setup: Ensure the scooter is fully charged.
- Mounting: Stand directly behind the ALL-STAR 2.0. Place one foot on the corresponding foot mat, keeping your weight on the foot still on the ground. Shift your weight to the foot on the scooter and quickly and evenly step on with your second foot. Stay relaxed and step on confidently.
- Balance: Find your center of gravity. If your weight is distributed correctly and your center of gravity is level, you should be able to stand steadily. It typically takes 3-5 minutes to get comfortable. A spotter can provide additional security.
- Movement: Your center of gravity dictates movement. Tilt your body in the desired direction to move forward, backward, accelerate, decelerate, or stop. To turn, focus on the direction you wish to go and remain relaxed. Avoid sharp turns or high speeds.
- Dismounting: From a stopped position, lift one leg and place your foot back on the ground (stepping back). Then, step off completely. Ensure your feet are completely off the foot mat to prevent the scooter from going into a tailspin.
Weight and Speed Limitations: For safety, adhere to the following limits: Maximum Weight: 220 lbs, Minimum Weight: 44 lbs, Maximum Speed: Up to 7 mph. Exceeding these limits can increase the risk of injury or product damage. When maximum speed is reached, the ALL-STAR 2.0 will beep and slowly tilt the rider back to alert them.
Operating Range: The ALL-STAR 2.0 can travel up to 7 miles on a full charge under ideal conditions. Factors affecting range include terrain (smooth, flat surfaces yield longer distances), user weight (lighter users have greater range), ambient temperature (recommended temperatures increase range and battery life), and speed/riding style (moderate, consistent speeds maximize distance, while frequent starts, stops, and high speeds reduce it).
Bluetooth Speaker: The ALL-STAR 2.0 has a built-in Bluetooth speaker.
- Pairing: Turn on the scooter; the speakers will "Ping" to indicate pairing mode. Place the scooter and your Bluetooth device within 3 feet. Enable Bluetooth on your device and select "DSA-STR2" from the list. Enter PIN "000000" if prompted. The scooter will say "Paired" upon success. Pairing mode lasts two minutes; if no device is paired, it returns to standby. If pairing fails, turn off and re-pair. If your smartphone is out of range or the scooter's battery is low, the speaker may disconnect. Reconnect by following the steps or recharging the scooter.
- Listening to Music: Once paired, stream music wirelessly. Only one speaker plays music, while the other is reserved for safety alerts. Volume and track controls are managed via your music device.
Safety Precautions:
- Always wear a helmet.
- Obey all local traffic laws (lights, one-way streets, stop signs, crosswalks).
- Ride with traffic, not against it.
- Ride defensively and expect the unexpected.
- Give pedestrians the right-of-way and alert them when passing.
- Slow down at intersections and look both ways.
- The ALL-STAR 2.0 is not equipped with reflectors; avoid riding in low visibility. If riding in low visibility (fog, dusk, night), wear bright, reflective clothing and keep headlights on.
- Do not ride beyond your skill level.
- Ensure the scooter is flat, powered on, and the Running Indicator is green before stepping on.
- Do not modify the ALL-STAR 2.0; this voids the warranty and can cause injury or death.
- Do not use the scooter in a way that endangers people or property.
- Maintain a safe distance from others.
- Keep feet on pedals at all times.
- Do not operate under the influence of drugs or alcohol, or when restless or sleepy.
- Do not ride off curbs, ramps, or in skate parks; it is not a skateboard. Misuse voids the warranty.
- Avoid continuous spinning, which can cause dizziness and increase injury risk.
- Do not abuse the scooter; physical abuse voids the warranty.
- Avoid puddles, mud, sand, stones, gravel, debris, or rough terrain.
- Use on flat, even paved surfaces. Lift over uneven pavement.
- Avoid riding in inclement weather (snow, rain, hail, ice, extreme heat/cold).
- Bend knees on bumpy surfaces to absorb shock and maintain balance.
- If unsure about terrain, dismount and carry the scooter.
- Do not ride over bumps or objects greater than ½ inch.
- Pay attention to surroundings (road conditions, people, property, objects).
- Avoid crowded areas.
- Use extreme caution indoors, especially around people, property, and narrow spaces.
- Do not operate while talking, texting, or looking at your phone.
- Do not ride where prohibited, or near motor vehicles/public roads.
- Do not travel up or down steep hills.
- Intended for single-person use; do not ride with two or more people.
- Do not carry anything while riding.
- Individuals with balance issues should not operate.
- Pregnant women should not operate.
- Recommended for riders ages 8 and older.
- At higher speeds, allow for longer stopping distances.
- Do not step forward off the scooter.
- Do not jump on or off, or attempt stunts/tricks.
- Avoid dark or poorly lit areas.
- Do not ride off-road, near potholes, cracks, or uneven surfaces.
- Be aware of increased height (4.72 inches/12 cm) when operating, especially through doorways.
- Do not step on the fenders.
- Avoid unsafe places with flammable gas, steam, liquid, dust, or fiber, which can cause fire/explosion.
- Do not operate near swimming pools or other bodies of water.
- When using a hoverboard with a kart (sold separately), avoid riding uphill on inclines above 5-10°. A safety mechanism will activate, shutting down the hoverboard. If this happens, dismount, place it on a flat surface, wait 2 minutes, and then power it on again.
- Adult supervision is required to reduce injury risk. Never use in roadways, near motor vehicles, on steep inclines/steps, swimming pools, or other bodies of water. Always wear shoes and allow only one rider.
Calibration: If the ALL-STAR 2.0 is unbalanced, vibrating, or not turning properly, calibrate it:
- Place the scooter on a flat, horizontal surface. Foot mats should be even.
- Ensure the charger is unplugged and the board is off.
- Press and hold the ON/OFF button for 5 seconds. The battery indicator will light up.
- Release the ON/OFF button after the light flashes 5 times.
- Turn the board off, then turn it back on. Calibration is complete.
Maintenance Features
Charging:
- Ensure the charging port is clean and dry, free of dust or debris.
- Plug the charger into a grounded wall outlet; the charger's indicator light will be green.
- Connect the power supply cable (100V ~ 240V; 50/60 Hz).
- Align and connect the 3-pin charging cable to the ALL-STAR 2.0's charging port. Do not force the charger, as this can damage the prongs or port.
- Once connected, the charger's indicator light will turn RED, indicating charging.
- When the charger's RED light turns GREEN, the ALL-STAR 2.0 is fully charged.
- A full charge takes up to 5 hours. While charging, a yellow flashing light on the scooter indicates charging. Do not charge for more than 7.5 hours.
- After charging, unplug the charger from the scooter and the power outlet.
Battery Care:
- The ALL-STAR 2.0 uses a built-in rechargeable lithium-ion battery. Do not disassemble the scooter to remove or separate the battery.
- Use only the supplied Hover-1 charger and cable. Using other chargers or cables can cause damage, overheating, fire risk, and voids the warranty.
- Do not connect the scooter or battery to a power supply plug or car's cigarette lighter.
- Do not place the scooter or batteries near fire or in direct sunlight. Heat can cause additional heating, breaking, or ignition.
- Do not continue charging if the battery does not recharge within the specified time; this can cause it to become hot, rupture, or ignite.
- Recycle or dispose of batteries properly. Lithium-ion batteries are hazardous materials; follow local, state, and federal laws for recycling and disposal.
- Do not modify, change, or replace the battery.
- Do not use the ALL-STAR 2.0 if the battery emits odor, overheats, or leaks.
- Do not touch leaking materials or breathe fumes.
- Do not allow children or animals to touch the battery.
- The battery contains dangerous substances; do not open it or insert anything into it.
- If the battery discharges or emits substances, immediately distance yourself from it due to fire or explosion risk.
- Seek immediate medical assistance if exposed to any substance emitted from the battery.
General Maintenance:
- Avoid exposing the ALL-STAR 2.0 to liquid, moisture, or humidity to prevent damage to internal circuitry.
- Do not use abrasive cleaning solvents.
- Avoid extremely high or low temperatures, which can shorten component life, destroy the battery, or distort plastic parts.
- Do not dispose of the ALL-STAR 2.0 in fire, as it may explode or combust.
- Avoid contact with sharp objects to prevent scratches and damage.
- Do not allow the ALL-STAR 2.0 to fall from high places, as this can damage internal circuitry.
- Do not attempt to disassemble the ALL-STAR 2.0 without permission, as this voids the warranty.
- Avoid using water or other liquids for cleaning; if they enter the scooter, permanent damage to internal components will occur.
Need help?
General
To Next Page
