PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your device out of the box and place it flat on the
floor. Press the power button (located on the rear of your device)
once. Check the LED indicator (located in the center of your
device). The battery indicator light should be lit, indicating the device
is powered on.
Power Off: Press the power button once.
MAT SENSOR
There are four sensors under the foot mats on your H1. When the user
steps off the scooter mats, it will automatically initiate self-calibration.
When riding the scooter, you must ensure you are stepping on the
foot mats. Do not step or stand on any other area of your scooter.
The H1 may vibrate or spin in one direction, if weight and pressure are
applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the H1 scooter.
• Green LED light indicates the device is charged above 20 percent.
• Yellow LED light indicates the power is under 20 percent.
• Red LED light indicates the power is down to 10 percent or lower.
When the LED light turns red, please recharge the device.
RUNNING INDICATOR
When the operator triggers the foot mats, the Running Indicator LED
will light up, which means that the system enters the running state.
When the system has an error during operation, the running LED light
will turn red (for more details see SAFETY ALERTS).
CONTROLS AND DISPLAY
6
To Next Page
Loading...
