Before each use, the E-Scooter operator shall perform the
pre-operation checks as specified below:
• The area that the unit is to be operated in is suitable for safe
operation.
• The braking system is functioning properly.
• All safety lables are in place and understood by the operator.
• Any and all axle guards or other covers and guards supplied by the
manufacturer are in place and in serviceable condition.
• The tires are in good condition, inflated properly, and have
sufficient tread remaining.
It is important that you fully understand all the functions of your Neo X
E-Scooter. If these functions are not used correctly, you will not have
full control of your Neo X.
Practice using your Neo X at slower speeds in a flat, open area until
you are comfortable riding it.
BEFORE RIDING
WARNING
Any Neo X E-Scooter that does not work
properly can cause you to lose control
and fall. Do not ride with any damaged
parts. Replace damaged parts before
riding.
KICK TO START
CRUISE CONTROL
Cruise control can be enabled/disabled by quick-pressing the power
button 3 times. If enabled, cruise control will automatically activate if
you maintain a constant speed for 5 seconds. You will hear a beep
when it activates. Cruise control allows you to ride at a constant
speed without using the throttle. Press the throttle down once or
engage the brake to cancel cruise control.
For safety reasons, the Neo X will not accelerate unless it is already
moving at least 3 mph (4.8 km/h). You must first kick off the ground to
get a rolling start and then press the throttle in order to ride the Neo V.
Kick to start can be disabled/re-enabled by quick-pressing the power
button 4 times.
21
To Next Page
