Contents
A
Instruction Booklet
B
Inlet Filter
C
Waterstop Connector
D
Pressure Washer
E
Handle & Fixing Screw
F
Wheels
G
High Pressure Hose
H
Detergent Tank
I
Gun
J
Lance Extension
K
Variable Spray Lance
L
Turbo Spray Lance
M
Nozzle Cleaning Tool
Read this manual through carefully before
installing/using the cleaner, paying special
attention to the SAFETY RULES/RESIDUAL
RISKS. To obtain the best performance from
your unit, read this booklet carefully and follow
the instructions each time you use the it.
•Thisapplianceisintendedfornon-professional
(domestic) use only.
Safety Rules/Residual Risks
SAFETY “DO NOTS”
High pressure jets can be dangerous if
subject to misuse. Do not direct the water jet
at people, animals, live electrical equipment
or the machine itself.
Do not use the machine within range of
people unless they wear protective clothing.
Do not direct the jet against yourself or
others in order to clean clothes or foot-wear.
Do not use the appliance outdoors in the
rain.
To avoid the risk of explosion, do not use the
appliance with inflammable or toxic liquids,
or any products which are not compatible
with the correct operation of the appliance.
High pressure washers must not be used by
children or persons with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction
concerning use of the high pressure washers
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
High pressure hoses, fittings and couplings
are important for the safety of the machine.
Use only hoses, fittings and couplings
recommended by the manufacturer.
Do not operate the product if it has a
damaged power cord or plug. If the power
cord or plug is damaged, it must be replaced
by a suitably qualified person.
Do not use the appliance if the high pressure
hose, the gun, lances or nozzles are
damaged.
Do not touch the plug and/or socket with
wet hands.
Do not jam the trigger in the operating
position.
Check that the rating plate is affixed to the
appliance. If not, inform your dealer. Units
without plates must not be used as they are
unidentifiable and potentially dangerous.
Do not tamper with or alter the calibration
of the safety valve.
Do not alter the original diameter of the
spray head nozzle. May cause hazardous
alteration of operating performance.
Do not leave the appliance unattended
when it is in operation.
Do not move the appliance by pulling on the
electrical cable.
Make sure that cars do not drive over the
high pressure hose.
SAFETY “DO’s”
All electrical conductors must be protected
against the water jet. The mains plug and
the coupling between the extension cable
must be water tight and never lay in the
water.
The appliance MUST ONLY BE CONNECTED to
an adequate power supply in compliance
with all applicable regulations.
Use of a Safety Residual Device (RCD) will
provide additional protection for the
operator (30 mA).
Wear protective clothing and safety goggles
to protect against splashback.
To Next Page
Loading...
