High pressure water can be
dangerous, always turn the power
to the pump off before
disconnecting the hose from the
pump
If the pump is running, and the
water is prevented from flowing
(eg. spraygun is in off mode) then
the water inside the pump can
become very hot. Never run the
pump for more than 10 minutes
without water flowing
Warning : Read this manual
carefully before installing this
pump.
This sign warns the user that
failure to follow an instruction may
damage the pump or the system
This sign warns the user of
important electrical safety
information.
Carefully store this manual.
If problems arise contact
Hozelock customer services.
Every Hozelock Garden Pump
is carefully tested and packed during
assembly.
On receipt, check that the pump has not
been damaged during transport. If the
pump is damaged, do not use, and
contact Hozelock customer services.
Check that the voltage and frequency
of pump shown on the rating label
corresponds to those available on the
mains.
ELECTRICAL INSTALLATION:
A 10MA OR 30MA RESIDUAL
CURRENT DEVICE (RCD)
MUST BE FITTED TO THE
MAINS SUPPLY.
PROTECT THE PLUG AND THE
POWER CABLE FROM HEAT,
OIL AND SHARP EDGES.
DO NOT OPERATE THE PUMP IF
IT HAS A DAMAGED POWER
CORD OR PLUG. IF THE POWER
CORD OR PLUG IS DAMAGED, IT
MUST BE REPLACED BY A
SUITABLY QUALIFIED PERSON IN
ORDER TO AVOID A HAZARD.
MAKE SURE THAT
ELECTRIC CONNECTIONS ARE
PROTECTED FROM WATER
& SPLASHES
THE INSTALLATION OF THE PUMP
SHOULD BE ON A STABLE FLAT
DRY SURFACE
THE PUMP MUST NOT BE
SUBMERGED
THE POWER CABLE SHOULD
HAVE A MINIMUM OF 3 CORE
0.75MM
2
SECTION EQUIVALENT
TO THAT OF H05 RN-F. TO MAKE
SURE THE PLUG IS PROTECTED
FROM ANY SPLASHES, USE THE
CABLE SUPPLIED TO CONNECT
AS FAR AWAY FROM THE PUMP
AS POSSIBLE
BEFORE USING THE PUMP,
ALWAYS INSPECT IT VISUALLY
(ESPECIALLY THE POWER CABLE
AND THE PLUG). DO NOT USE
THE PUMP IF IT IS DAMAGED.
NEVER USE THE POWER CABLE
TO LIFT THE PUMP.
Electrical SafetyGeneral Safety
To Next Page
Loading...
