minutes - stop and repeat steps 6 to
10.
TO CONNECT TO AN IRRIGATION
SYSTEM:
■
For use with hoses and hose reels
add a 2166 hose connector
(available separately) .
• The Hozelock Garden Pump has a
built in thermal protection switch.
The pump stops if an overload
condition occurs. The motor restarts
automatically after it has cooled
down.
• Insert the plug into a 220-240v A/C
socket.
Make sure that the pump is
disconnected from the electric
power supply before performing
any maintenance.
If pump performance drops it may
be because the two filters in the kit
have become clogged, and require
cleaning.
Regularly check the coarse filter on
the end of the suction hose, and
clean if required. After checking or
cleaning the pump, reprime, see
steps F-J.
Regularly check fine filter fitted
prior to the pump, and clean if
required.
Use the large plastic spanner
supplied to loosen large yellow
locking nut.
Remove cup and filter, clean under a
tap. Do not scrub.
Reassemble, and make sure the nut
is tightened securely - use spanner
provided.
• Disconnect hose and loosen bottom
red nut and allow to drain.
• Store the pump in a dry place and
protect from frost.
M
L
K
Overload protection
Maintenance
Pump storage
To start the pump
To Next Page
Loading...
