EasyManuals Logo

HP Enterprise HPE 5820 Switch Series User Manual

HP Enterprise HPE 5820 Switch Series
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
36
[DeviceB-irf-port2/1] port group interface ten-gigabitethernet 2/0/26
[DeviceB-irf-port2/1] quit
[DeviceB] interface ten-gigabitethernet 2/0/26
[DeviceB-Ten-GigabitEthernet2/0/26] undo shutdown
[DeviceB-Ten-GigabitEthernet2/0/26] save
# Activate IRF port configuration on Device A.
[DeviceA-Ten-GigabitEthernet1/0/25] quit
[DeviceA] irf-port-configuration active
# Activate IRF port configuration on Device B.
[DeviceB-Ten-GigabitEthernet2/0/26] quit
[DeviceB] irf-port-configuration active
After the IRF port configuration is activated, the two devices automatically elect a master. In this
example, Device A is the master. Device B automatically reboots and joins the Device A as a
subordinate switch to form an IRF fabric. The system name of the IRF fabric is DevcieA.
4. Configure ARP MAD:
# Enable the spanning tree feature globally on the IRF fabric to prevent loops.
<DeviceA> system-view
[DeviceA] stp enable
# Connect the ARP MAD links as shown in Figure 15.
# Configure the IRF fabric to change its bridge MAC address as soon as the master leaves.
[DeviceA] undo irf mac-address persistent
# Create VLAN 3, and add port GigabitEthernet 1/0/1 (on Device A) and port GigabitEthernet
2/0/1 (on Device B) to VLAN 3.
[DeviceA] vlan 3
[DeviceA-vlan3] port gigabitethernet 1/0/1 gigabitethernet 2/0/1
[DeviceA-vlan3] quit
# Create VLAN-interface 3, assign it an IP address, and enable ARP MAD on the interface.
Because ARP MAD is not run between IRF domains, you can use the default value 0.
[DeviceA] interface vlan-interface 3
[DeviceA-Vlan-interface3] ip address 192.168.2.1 24
[DeviceA-Vlan-interface3] mad arp enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]:
The assigned domain ID is: 0
5. Configure Device C:
# Enable the spanning tree feature globally on Device C to prevent loops.
<DeviceC> system-view
[DeviceC] stp enable
# Create VLAN 3, and add GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to VLAN 3.
[DeviceC] vlan 3
[DeviceC-vlan3] port gigabitethernet 1/0/1 gigabitethernet 1/0/2
[DeviceC-vlan3] quit

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Enterprise HPE 5820 Switch Series and is the answer not in the manual?

HP Enterprise HPE 5820 Switch Series Specifications

General IconGeneral
BrandHP Enterprise
ModelHPE 5820 Switch Series
CategorySwitch
LanguageEnglish

Related product manuals