HP 10430A - Accessories Supplied

HP 10400A OPERATING NOTE
ACCESSORIES SUPPLIED
The following accessories are supplied with
each probe of the HP 10400A family:
General Purpose Grabber. One general
purpose grabber is supplied with each probe
model. The general purpose grabber is
attached to the probe tip for use on 1C pins
and other typical circuit measurements. HP
Part Number 5061-6160,
Integrated Circuit Grabber. One integrated
circuit (IC) grabber is supplied with each probe
model. The IC grabber is attached to the
probe tip to allow easy and firm grip to an IC
without the hazard of shorting adjacent pins
on the IC. HP Part Number 5061-6161.
Ground Lead. One ground lead with alligator
clip is supplied with each probe model. The
ground lead has a ferrite bead included in its
construction which reduces noise In the
measured signal. HP Part Number 5061-6162.
Barrel Insulator. One barrel insulator is
supplied installed on the tip of each probe
model. The barrel insulator prevents possible
shorting of probe tip and circuitry. Use barrel
Insulator with the general purpose grabber for
correct fit of grabber.
Accessory Package. One accessory package
is supplied with each passive probe. The
accessory package contains: four grounding
spanners, one barrel insulator, eight colored
cable markers, and one adjustment
screwdriver.
2