To Next Page

To Previous Page

I/O card not ready

for HP Jetdirect 175x external print server/Internet connector for USB

and HP Jetdirect 310x external print server/Internet connector for USB

Check the following items to see whether you can correct the “I/O Card Not Ready” situation. (If you have

already performed these steps earlier in the troubleshooting process, you can skip them and go directly to

answering the question at the end of the steps.)

1. Make sure that the network cable is connected securely to the print server.

network cable

2. Check that the network cable is plugged securely into the hub/switch/router, and that the

connection is set to the correct network speed.

3. Check that the LINK light is ON for the port on the hub/switch/router to which the print server is

connected.

4. Your network cable may be faulty. Try a different cable.

5. If the light still does not come on, try a different port on the hub/switch/router.

If you made any changes, please print another configuration page. Does the page show

“I/O Card Ready” now?

Questions and Answers:

Need help?

Do you have a question about the HP 175X - JetDirect Print Server and is the answer not in the manual?

HP 175X - JetDirect Print Server Specifications

General