Speakers
Description Spare part number
Speakers (includes left and right speakers and cable) 926558-001
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 32).
5. Remove the optical drive (see Optical drive on page 34).
6. Remove the bottom cover (see Bottom cover on page 41).
To remove the speakers:
1. Disconnect the speaker cable from the system board (1).
2. Remove the cable from the routing path (2).
3. Lift the speakers out of the computer (3).
NOTE: When installing the speakers, make sure the rubber grommets (4) that secure the speakers are
correctly installed.
Reverse this procedure to install the speakers.
Component replacement procedures 57
To Next Page
Loading...
