9. To remove the display/webcam cable, lift the cable (1) from the clips built into the display panel (2), and
then remove the cable from the display.
10. If replacing the display enclosure, be sure that the subcomponents (including the webcam/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
Reverse this procedure to reassemble and install the display assembly.
When reassembling and reinstalling the display assembly, use the following images to determine how to
correct route the cables in the display. In the following image, note the location to route the antenna cables
(1) and display/webcam cable routing bracket (2).
In the following image, note the correctly routed antenna cables (1) and display/webcam cable (2).
Component replacement procedures 77
To Next Page
Loading...
