HP 1810 User Manual

1-3
Getting Started
Getting Started With the Web Interface
Getting Started With the Web Interface
This section describes the following Web pages:
■ “Logging On” on page 1-3
■ “Interface Layout and Features” on page 1-3
Logging On
Follow these steps to log on through Web interface:
1. Open a Web browser and enter the IP address of the switch in the Web browser address field.
2. On the Login page, enter the password (if one has been set), and then click Login.
By default, there is no password. After the initial log on, the administrator may configure a
password.
Note To set passwords, see “Password Manager” on page 10-7.
Figure 1-1. Login Page
Interface Layout and Features
Figure 1-2 shows the initial view.

HP 1810 Specifications

General

Layer	Layer 2
PoE	No
VLAN Support	Yes
Energy Efficient Ethernet (EEE)	Yes
Switching capacity	16 Gbps
Throughput	11.9 Mpps
Form factor	Desktop
Jumbo Frame Support	Yes
Quality of Service (QoS)	Yes
Ports	8 x 10/100/1000