1-6
Getting Started
Getting Started With the Web Interface
• Off—The switch is NOT receiving power.
■ Fault (Orange)
• Blinking—A fault has occurred, other than during self-test.
• On—Self-test in progress.
• Off—The switch is operating properly.
■ Locator (Blue)
• Blinking—The switch is in Locate mode, attempting to locate a specific switch.
• Off—The locator is disabled. This mode can be enabled using the Web interface. See “Locator”
on page 9-5.
Port LEDs
Each 10/100/1000 Mbps RJ45 port has two single color LEDs to indicate the, Link/Activity on the Left
port LED and the Speed status indicated by the Right port LED.
The left-port LED indicates link status, as follows:
■ On—The port is enabled and receiving a link indication or other signal from the connected
device.
■ Blinking—The port has network activity.
■ Off—The port has no active network cable connected, is not receiving link signal, or is
disabled.
The right-port LED indicates speed status, as follows:
■ On—The port is operating continuously at 1000 Mbps.
■ Blinking—The port is operating at 100 Mbps.
■ Off—The port is operating at 10 Mbps.
Note The PD LEDs on the HP1810-8G glow when the switch is powered via the PD Port 1 using an external
PoE device.
To Next Page
Loading...
