EasyManuals Logo

HP 2000 User Manual

HP 2000
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
Determining the BIOS version
To determine whether available BIOS updates contain later BIOS versions than those currently
installed on the computer, you need to know the version of the system BIOS currently installed.
BIOS version information (also known as ROM date and System BIOS) can be displayed by pressing
fn+esc (if you are already in Windows) or by using Setup Utility.
1. Start Setup Utility (BIOS).
2. Use the arrow keys to select Main.
3. To exit Setup Utility (BIOS) without saving your changes, use the tab key and the arrow keys to
select Exit > Exit Discarding Changes, and then press enter.
Downloading a BIOS update
CAUTION: To reduce the risk of damage to the computer or an unsuccessful installation, download
and install a BIOS update only when the computer is connected to reliable external power using the
AC adapter. Do not download or install a BIOS update while the computer is running on battery
power, docked in an optional docking device, or connected to an optional power source. During the
download and installation, follow these instructions:
Do not disconnect power from the computer by unplugging the power cord from the AC outlet.
Do not shut down the computer or initiate Sleep or Hibernation.
Do not insert, remove, connect, or disconnect any device, cable, or cord.
1. Windows 7—Select Start > Help and Support > Maintain.
Windows XP—Select Start > Help and Support, and then select the software and
drivers update.
2. Follow the on-screen instructions to identify your computer and access the BIOS update you
want to download.
3. At the download area, follow these steps:
a. Identify the BIOS update that is later than the BIOS version currently installed on your
computer. Make a note of the date, name, or other identifier. You may need this information
to locate the update later, after it has been downloaded to your hard drive.
b. Follow the on-screen instructions to download your selection to the hard drive. Make a note
of the path to the location on your hard drive where the BIOS update is downloaded. You
will need to access this path when you are ready to install the update.
NOTE: If you connect your computer to a network, consult the network administrator
before installing any software updates, especially system BIOS updates.
BIOS installation procedures vary. Follow any instructions that are displayed on the screen after the
download is complete. If no instructions are displayed, follow these steps:
1. Windows 7—Open Windows Explorer by selecting Start > Computer.
Windows XP—Open Windows Explorer by selecting Start > My Computer.
2. Double-click your hard drive designation. The hard drive designation is typically Local Disk (C:).
Using Setup Utility 85

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 2000 and is the answer not in the manual?

HP 2000 Specifications

General IconGeneral
Bus typeDMI
SteppingQ0
Tjunction85 °C
Processor cache2 MB
Processor cores2
Processor modelB960
System bus rate5 GT/s
Processor familyIntel® Pentium®
Processor seriesIntel Pentium B900 Series for Mobile
Processor socketSocket 988
Processor codenameSandy Bridge
Processor frequency2.2 GHz
Processor cache typeL3
Processor lithography32 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version2.0
Processor operating modes64-bit
ECC supported by processorNo
PCI Express configurations1x16, 2x8, 1x8+2x4
Thermal Design Power (TDP)35 W
CPU multiplier (bus/core ratio)22
Maximum number of PCI Express lanes16
Motherboard chipset-
Memory slots2x SO-DIMM
Internal memory2 GB
Memory form factorSO-DIMM
Internal memory typeDDR3-SDRAM
Maximum internal memory8 GB
Memory layout (slots x size)1 x 2 GB
AC adapter includedYes
Disc types supportedCD, DVD
HDD size2.5 \
HDD speed5400 RPM
HDD interfaceSATA
Storage mediaHDD
Optical drive typeDVD Super Multi
Total storage capacity500 GB
Compatible memory cardsMMC, SD
Number of HDDs installed1
Number of SSDs installed0
Display surfaceGloss
Display diagonal15.6 \
Display resolution1366 x 768 pixels
Native aspect ratio16:9
Display number of colors16.78 million colors
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics
On-board graphics card base frequency650 MHz
On-board graphics card dynamic frequency (max)1100 MHz
CD read speed24 x
CD rewrite speed10 x
DVD+R read speed8 x
DVD-RW write speed6 x
Speakers manufacturerAltec Lansing
WWANNot installed
Data networkNot supported
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology10/100Base-T(X)
Ethernet LAN data rates10, 100 Mbit/s
Charging port typeDC-in jack
Headphone connectivity3.5 mm
USB 2.0 ports quantity3
Pointing deviceTouchpad
Operating system installedFreeDOS
Form factorClamshell
Product typeLaptop
Product colorBlack
Country of originChina
Processor codeSR07V
Processor ARK ID59836
Processor package size37.5x37.5 (rPGA988B) mm
Supported instruction setsSSE4.1, SSE4.2
Battery life (max)- h
Number of battery cells6
AC adapter power65 W
AC adapter frequency50 - 60 Hz
AC adapter input voltage100 - 240 V
Cables includedAC
Operating altitude0 - 3050 m
Non-operating altitude0 - 4570 m
Storage temperature (T-T)-15 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)5 - 80 %
Sustainability certificatesRoHS, ENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Depth247 mm
Width376 mm
Height35.8 mm
Weight2450 g

Related product manuals