a. Detach the camera module (1) from the display back cover. (The module is attached with double-
sided adhesive.)
The HD camera module is available using spare part number L23237-001.
The VGA camera module is available using spare part number L23238-001.
b. Disconnect the cable (2) from the camera/microphone module.
3. If it is necessary to replace the display panel:
a. Remove the four Phillips M2.0 × 3.0 screws that secure the panel to the display enclosure.
b. Swing the top edge of the display panel forward and position the panel upside down next to the
display enclosure (1).
c. Release the adhesive support strip (2) that secures the display panel cable connector to the
display panel.
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
