HP 2510-24 User Manual

2-1
Installing the Switch
2
Installing the Switch
The ProCurve Series 2510 Switch is easy to install. It comes with an accessory
kit that includes the brackets for mounting the switch in a standard 19-inch
telco rack, in an equipment cabinet, on a wall, and with rubber feet that can
be attached so the switch can be securely located on a horizontal surface. The
brackets are designed to allow mounting the switch in a variety of locations
and orientations. This chapter shows how to install the switch.
Included Parts
The Series 2510 Switch has the following components shipped with it:
■ ProCurve Series 2510 Switch Installation and Getting Started Guide
(5991-3833), this manual
■ Read Me First
■ Console cable (5188-3836)
■ Customer Support/Warranty booklet
■ Accessory kit
5064-2085
two mounting brackets
four 8-mm M4 screws to attach the
mounting brackets to the switch
four 5/8-inch number 12-24 screws to attach
the switch to a rack
four rubber feet

HP 2510-24 Specifications

General

Switching Capacity	8.8 Gbps
Layer	Layer 2
Jumbo Frame Support	Yes
Ports	24 x 10/100
Management	Web-managed
Operating Temperature	0°C to 45°C
Weight	3.08 kg