3
RoHS (2002/95/EC) requirements
Applied to all countries that require RoHS.
The RoHS (Restriction of Hazardous Substance in Electrical and Electronic
Equipment Directive) is a legal requirement by the EU (European Union) for the global
electronics industry sold in the EU and other countries. Any electrical and electronics
products launched in the market after June 2006 should meet this RoHS requirement.
Products launched in the market before June 2006 are not required to be compliant
with RoHS parts. If the original parts are not RoHS complaint, the replacement parts
can be non-ROHS complaint. If the original parts are RoHS compliant, the
replacement parts MUST be RoHS complaint.
If product service or maintenance requires replacing parts, confirm the RoHS
requirement before replacement.
General descriptions
This manual contains general information. There are two levels of service:
Level 1: Cosmetic/appearance/alignment service
Level 2: Circuit board or standard parts replacement
Before return to receiver:
Please always perform an AC leakage current check on the exposed metallic parts to
be sure the set is safe to operate without damage of electrical shock.
Do not use a line Isolation Transformer during this check.
In case any measurement is out of the limits specified, there is possibility of shock
hazard and the set must be checked and repaired before it is returned to the customer.
To Next Page
Loading...
Need help?
General
