To Next Page

To Previous Page

7. Click the System Requirements tab, and then verify that your system meets the program

minimum requirements.

8. Click Download and follow the on-screen instructions to download

My Display

Using Auto-Sleep Mode

The display supports an OSD (On-Screen Display) option called Auto-Sleep Mode that allows you to

enable or disable a reduced power state for the display. When Auto-Sleep Mode is enabled (enabled

by default), the monitor will enter a reduced power state when the host PC signals low power mode

(absence of either horizontal or vertical sync signal).

Upon entering this reduced power state sleep mode, the monitor screen is blanked, the backlight is

turned off and the power LED indicator turns amber. The monitor draws less than 0.5W of power

when in this reduced power mode. The monitor will wake from the sleep mode when the host PC

sends an active signal to the monitor (for example, if you activate the mouse or keyboard).

You can disable the Auto-Sleep Mode in the OSD. Press the Menu button on the side panel to open

the OSD. In the OSD select Power Control > Auto-Sleep Mode > Off.

Using Auto-Sleep Mode 19

Questions and Answers:

Need help?

Do you have a question about the HP 27xw and is the answer not in the manual?

HP 27xw Specifications

General