HP 2820

Changing the default glass-size setting
This setting determines which paper size the flatbed scanner scans when you send a fax
from the scanner. The factory-set default is determined by the region/country in which you
purchased the device.
To change the default glass-size setting
1. On the device control panel, press M ENU .
2. Use the < or the > button to select Fax setup, and then press E
NTER .
3. Use the < or the > button to select Fax Send setup, and then press E
NTER .
4. Use the < or the > button to select Def. Glass Size, and then press E
NTER .
5. Use the < or the > button to select the correct paper size setting: A4 or Letter.
6. Press E
NTER to save your selection.
ENWW Changing the default glass-size setting 89