Selecting tone-dialing or pulse-dialing mode
Use this procedure to set the device to tone-dialing or pulse-dialing mode. The factory-set
default is Tone. Do not change this setting unless you know that your telephone line cannot
use tone dialing.
To select tone-dialing or pulse-dialing
1. On the device control panel, press M
ENU
.
2. Use the < or the > button to select Fax setup, and then press E
NTER
.
3. Use the < or the > button to select Fax Send setup, and then press E
NTER
.
4. Use the < or the > button to select Dialing Mode, and then press E
NTER
.
5. Use the < or the > button to select Tone or Pulse, and then press E
NTER
to save your
selection.
Note
The pulse-dialing option is not available in all regions/countries.
90 Chapter 8 Fax ENWW
To Next Page
Loading...