Description Spare part number
●
250-GB, 7200-rpm 649904-001
Hard Drive Mounting Kit (includes mounting bracket and screws) 637177-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation mode,
turn on the computer, and then shut it down using the operating system.
2. Disconnect all of the external devices that are connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 32).
Remove the hard drive:
To remove the hard drive, follow these steps:
1. Save your work and shut down the computer.
2. Disconnect all of the external devices that are connected to the computer.
3. Unplug the power cord from the AC outlet, if necessary.
4. Turn the computer upside down on a flat surface and remove the battery.
5. Lift up at the two indentations (1) to remove the service cover (2).
34 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
Need help?
General
