c.
Optical drive (see
Optical drive on page 50)
d. Keyboard (see
Keyboard on page 52)
NOTE: When replacing the top cover, be sure that the following components are removed from the
defective top cover and installed on the replacement top cover:
●
Fingerprint reader module (See
Fingerprint reader module on page 59)
●
TouchPad button board (See
TouchPad button board on page 60)
●
Card reader board (See
Card reader board on page 62)
●
Power button board (See
Power button board on page 63)
Remove the top cover:
1. Close the computer.
2. Turn the computer upside down with the front toward you.
3.
Remove the two rubber feet (1).
NOTE: The rubber feet are included in the Rubber Kit, spare part number 746669-001.
4. Remove the ten Phillips PM2.5×6.5 screws (2) that secure the top cover to the base enclosure.
5. Remove the two Phillips PM2.0×2.0 broad head screws (1) in the optical drive bay that secure
the top cover to the base enclosure.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
