EN Chapter 3 Printer operation 71
CFG IPX/SPX=NO NO
YES
Select whether you want to use the IPX/
SPX menu and set IPX/SPX protocol
parameters.
NO
: Bypass the IPX/SPX menu items.
YES
: Use the IPX/SPX menu items.
In the IPX/SPX menu, you can specify
the frame-type parameter used on your
network.
The default is
AUTO
, to automatically set
and limit the frame type to the first one
detected.
For Ethernet cards, frame type
selections are
EN_8023, EN_II,
EN_8022, EN_SNAP
.
For Token Ring cards, frame type
selections include
TR_8022, TR_SNAP
.
In the IPX/SPX menu for Token Ring
cards, you can also specify NetWare
Source Routing parameters, which are
SRC RT=AUTO
(default),
OFF
,
SINGLE R
, or
ALL RT
.
CFG TCP/IP=NO NO
YES
Select whether you want to use the
TCP/IP menu and set TCP/IP protocol
parameters.
NO
: Bypass the TCP/IP menu items.
YES
: Use the TCP/IP menu items.
In the TCP/IP menu, you can specify
BOOTP=YES
or
DHCP=YES
for TCP/IP
parameters to be automatically loaded
from a bootP or DHCP server when the
printer is turned on.
If you specify
BOOTP=NO
and
DHCP=NO
, you
can manually set the following TCP/IP
parameters from the control panel: each
byte of the IP address (IP), Subnet Mask
(SM), Syslog Server (LG), and Default
Gateway (GW). You can also manually
set the idle timeout period.
Print an HP JetDirect configuration page
to verify your settings. However, note that
the print server might overwrite selected
parameters with values that ensure
proper operation.
Table 27. EIO menu (continued)
Item Values Explanation
To Next Page
Loading...