HP 532A - Page 3

Page 4
Table 2. Required Test Equipment
Model 532A/B
Equipment
Critical Specifications
Recommended HP Model
Oscilloscope
Osciiloscynchroscope 130C
Adapter (2)
Coax to waveguide
Band of interest 281A
Adapter
(Waveguide to waveguide)
Bands of interest MP292B (M-band tests only)
Coaxial Attenuator 12 dB in 1 dB steps 200 MHz 355C
Waveguide Attenuator Continuously variable to 20 dB
375A
Crystal Detector Sensitivity: 0.3 mV/|uW
424A (423A with 281A adapter
may be substituted for G-, J-,
H-, and X-band tests)
Thermistor Mount
Band of interest. Matches Power Meter 486A
Power Meter
Matches Thermistor Mount 431B/C
Electronic Counter Frequency: to 200 MHz
5245L with 5253B plug-in
Transfer Oscillator Stable 200 MHz oscillator with 3.95 GHz
mixer and video amplifier
540B
Directional Coupler Band of interest: 3 dB
752A
Harmonic Mixer Input Frequency: 12.4-18.0 GHz
Output: 0.4 mV with 0 dBm input
932A (M- and P-bandtests only)
Sweep Oscillator
Band of interest
Leveling: remote, -V proportional to RF
Modulation: INT AM 1000 Hz square wave
8690 mainframe with:
G- and J-band H01-8693B
H- and X-band H01-8694A/B
M-band 8695A (special)
P-band 8695A
Low-Pass Filter
Passband: Band of interest
Reject: Harmonics
G-band Microphase LTP 6000
J-band Microphase LTP 8200
H-band Microphase LTP 10500
X-band HP X362A
M-band HP M362A
P-band HP P362A
Isolator
Isolation: > 30 dB
G-band Ferrotec I-152L
J-band Ferrotec I-153L
H-band Ferrotec I-154L
X-band Ferrotec I-155L
M-band Ferrotec I-744L
P-band Ferrotec I-156L
Table 3. Test Card
i
Hewlett Packard Model 532A/B
Date
Frequency Meter
Tested by
FREQUENCY DIAL CALIBRATION
Maximum Dial Error
%
Specification
%
POWER DIP
High End of Band
dB Specifications > 1 dB
Center of Band
dB Specifications > 1 dB
Low End of Band
dB Specifications > 1 dB
00245-5