HP 5344S User Manual

Model 8756A
Operating Information
CRS
f- .
R(F!
'"~
~~
I
v
I. 5 Bm
l
4. I
00 Hz
r--
~-
----
/I
1/
I
i
T
(a)
\
L~
'
CURSOR
tUN I
CURSOR
MlNi!
CURSOR Menu
CRS~ 3. BB dB
1.3 ee Hz
t
\
1\
I
-\
1---
1/
v
\
(b)
' """""'
ON-' OfT
CURSOR
MIN I
CURSOR
t1IN2
CUR
'"
_/
OR OFF
'
i
J
1\
I \
1/
(c)
When CURSOR is selected on the MAIN MENU, the CRT will appear
as shown in (a), with the CURSOR (+ symbol) turned ON.
\
CURSOR ON/OFF alternately turns the CURSOR ON, as shown in (a),
and OFF, as shown in (c). When ON, the CURSOR appears on any
of the active data traces. The Knob is used to move the CURSOR
to any point on the data traces. The amplitude of the
measurement for a selected channel appears in the upper right
corner of the MODE LABEL, and also appears in the ACTIVE ENTRY
AREA for the Active Channel. This amplitude is always the
selected MEASurement and DISPLAY reading, resolved to 0.01 dB,
regardless of the SCALE per division or REFerence LEVEL value.
If either the 8350B Sweep Oscillator or the 8340A Synthesized
Sweeper HP-IB is connected to the 8756 SYSTEM INTERFACE, the
CURSOR frequency value appears in the FREQUENCY LABELS and also
in the ACTIVE ENTRY AREA for the Active Channel. When
Alternate Sweep is selected, both CURSOR frequencies will
appear for each sweep in the FREQUENCY LABELS.
Figure 3-2. Soft Key Operating Features (2 of 10)
'
ORSOAO
ON/OFF
CURSOR
MIN l
CURSOR
MlN2
3-15

HP 5344S Specifications

General

Brand	HP
Model	5344S
Category	Measuring Instruments
Language	English