2-1
Installing the HP 5400R zl2
Switches
2
Installing the HP 5400R zl2 Switches
The HP 5400R zl2 switches come with an accessory kit that includes the
brackets for mounting the switch in a standard 19-inch telco rack, or in an
equipment cabinet. The switches have rubber feet already attached so they
can be securely located on a horizontal surface. This chapter shows you how
to install your HP 5400R zl2 switches.
Included Parts
The 5400R zl2 switches have the following components shipped with them:
■ HP 5400R zl2 Switch Quick Setup Guide and Safety/Regulatory Informa-
tion
■ HP Switches General Safety and Regulatory Information
■ One HP 5400R zl2 Management Module (J9827A)
■ One HP 5406R zl2 Switch Fan Tray (J9831A) or HP 5412R zl2 Switch Fan
Tray (J9832A)
■ One HP 5406R zl2 Switch Rack Mounting Kit (5066-3042) or HP 5412R zl2
Switch Rack Mounting Kit (5066-3043)
■ Cable Manager Kit (5189-8716)
Note Power Supplies are not included with the HP 5400R zl2 Switches. They are to
be ordered separately. Each of the 5406R switches come with two power
supply slots and the 5412R switches come with four power supply slots. Three
different power supplies are available to be used with the switches: J9828A,
J9829A, and J9830A.
To Next Page
Loading...
Need help?
General