HP 54501A - Vertical Setup

- Vertical Setup
E QS &
ð 0 pe] Q
offset ——- sate
0.00000 v]
a o
æ]
(BW lim
a
preset
more probe
> eS ais
9450 1W10
CHANNEL (MORE }
as a
seme Seine Je
5450 {W11
The vertical setup displays the signal at most amplitude levels.
e Press CHAN Menu key.
Channel menu is displayed along the right edge of
the display and volts/divison is active function
(displayed in full-bright inverse video.)
e Press more key.
e Change probe attenuation to 10:1 (attenuation of probe supplied with
oscilloscope) with keypad or knob.
Notice the voltage information
changes but the displayed waveform
does not.
e Press more key again to return to the first channel menu and rotate
the knob slowly.
The volts/division changes and the waveform
amplitude on the display changes.
Notice the volts/division changes in
much smaller increments because of
the change in probe attenuation.
e Enter 250 mvolts.
Press 2,5, 0, mV keys in order. The unit key
completes the entry.
HP 54501A, HP 54502A and HP 54503A instant Setup
Getting Started Guide
3-3