HP 54520 Series - Waveform Compare Menu

Figure 8-4
Define Measure Menu
Waveform Compare Menu
Waveform Compare Menu
The waveform compare test allows a point-by-point comparison of an input
channel to a waveform memory pair (ml and m2, or m3 and m4). The result
is a displayed PASS or FAIL message. The menu allows you to compare your
choice of input channel or function with a memory pair. You can enter a
failure allowance value to give the effect of trace separation, where needed.
On failure, the menu allows for storage of the data with a stop/continue
option.
If limit test is on, you cannot turn on the compare test.
DEFINE MEAS
measure detina
Viumit
- test
on
- compare
chan
Tune 1
- tO
upper ms
lower ma
- allowance
Po.000 eer
- on fail.save _
i after fail ——
GU continue
8-14