HP 54520 Series - Page 158

Waveform Save Menu
Multiple Menu
View Failures Softkey
The view failures softkey toggles the multiple memory display on or off.
If failure data was not saved, the softkey remains off and a message stating
that the multiple memory is empty is displayed.
Store Failure Softkey
The store failure softkey saves the specified multiple memory to the
currently selected nonvolatile memory location. When pressed, the memory
is erased and new data is stored to the memory. If the destination memory is
protected, the message "protect on: cannot store waveform" indicating that
the store was not successful is displayed. If failure data was not saved, the
status message "no valid data... nothing stored” is displayed.
Protect Softkey
The protect softkey toggles the selected waveform memory write protect
to on or off. When on is selected, any attempt to store data is not allowed,
and the message "protect on: cannot store to memory" is displayed.
Any data stored to the multiple memories is lost when the power is cycled.