Load paper to Tray 1 (multi-purpose tray)
Introduction
The following information describes how to load paper into Tray 1. This tray holds up to 50 sheets of 75 g/m2
(20 lb) paper or 5 envelopes.
NOTE: Select the correct paper type in the print driver before printing.
CAUTION: To avoid jams, never add or remove paper from Tray 1 during printing.
1. Open Tray 1.
2. Pull out the tray extension to support the paper.
3. Spread the paper guides to the correct size, and
then load paper in the tray. For information about
how to orient the paper, see Tray 1 paper
orientation on page 19.
18 Chapter 2 Paper trays ENWW
To Next Page
Loading...