HP 8593A

code indicates the type of error. Error codes are described in the spectrum
analyzen Service Mannuai, (Ii).
FREQ UNCAL
Inudmcates a YTO-tuning failnure, ‘This may occur when using dcfaolt
correction factors. Performing the CAL FREQ routine may eliminate the
failure. It does not indicate a problem if the FREQ UNC,&L message
appears briefly dmuning the CAL FREQ routine or when the frequency value
in changed. (U) and (II)
INTILNLLOCKED
The apertrmuun analyzer’s internal trace and state registers have been locked.
To onulock the trace or state registers, press SAV LOCK ON OFF so that OFF
is underlined. For remote operation, muse PSTATE OFF. (C)
INVALID ACTDEE: - - -
Time specified ACTDEF name is not vahui. See the ACTDEF progcauonning
coununnaund. (C)
INVALII) AMPCOR: FREQ
For tine ALIPCOIL conunuaa.nd, tine frcqnncnucy miata unust be inn incmeasing order.
See the ALIPCOR prsngnannniiuug connunuand, (L)
INVALID ACN1TS:_ — —
‘l’he anuphtudc munnits are nuot valid. Sec the ±\UNITS progranunning conumnuanul.
(U)
INVALID BLOCK FORMAT: IF STATEMENT
An invalid lalock format appeared witinin the IF’ stateunent. (U)
INVALID CARD:DIRECTORY
Inudicates the memory mard has not been formatted. (U)
IN VALID CARD: NO CARD
Indicates a memory card has not beenu iuuscrted. (U)
INVALID CAITI)
Indicates one of the follow-lug counditions: a card reader is not installed, time
menoory card is write-protected, the memory cacd is a read-only card, or a
nnemory card has not been inserted. Tiuis unessage can also ocrun if remote
programming conumnands fuur line nuncunory carsi capability are execunted witin
an lIP 859011 or lIP 859211 that mInes not inave an Option 003. (U)
A-4 Spectrum Analyzer Error Messages