HP 8593A

3
Programming Commands
Introduction
Thin’ following pagu’s are a conuipilzitioui of all cuurreuut ~urogramui musing conruunianuuls
for the lIP 8591) Series spect run iii a mu a lvzers. More iii fornuu at ion our each i
corn nm arm ml cain hue fomu mud i mu thu u’ tIP 8590 5’cric,s .S’~s c(rmu nun ih uumu/yzcr I’rogro mu mu inmg
Manmmmul. l’huis chiuupter comutaini the following sectiu,mus:
• ]Iosv to unse thus chapter.
N otationu courveuntioni s.
Sv nut ax con venutions.
• The fuu nucthonuah i numhex.
• T hue prognuurmu ui h mug comIcs.
• ‘flue smunuunnnarv of blue dun carters uumuul su’couiuharv kevwonh s ( reserveul words)
How to Use This Chapter
This chapter is inuteuuuleuh experiu’nuceul spectnunnur analyzer prograunrmmuu’rs.
To find a program ni nig coihe that perfornmm s a liii rticmnla r funuctiouu , refer to
the “Fuiructional luuihuux.” whuichu gruuuu~us Slur’ comnuiuuaninls uuruormluuug to function.
Once the mlesireul comuuummanud is fomumsul, refer to tIne alphuahuurtical histinug of thin
lurogramnunuuimig coils’s for fuurmhuu’r lsu’ywonul uhu’fimuitiuuuu anuul svnrtnux inufmunururutiouu.
For funrthner iii forunuat ion omu syrmt ax, refer to ‘Not atiuunu Conuvm’untionus .““ Svuutax
Comuvemu tionu s,” an ul “Chin rnuc ters amu ul Secouuula ny Km’yworuhs (II esuumveuh \\ords
Smnumrniary.”
Programming Commands 3-1