HP 8593A

NRL Sets the inonniahizeul nu’fenennci’ hu’vel.
R.LPOS Selects tIne Inositionu of refenenice lurvel.
SPEAK Eli Tmi runs omu on off the i niterninil spu’a ken. For Opbnosm 102. 103, on
.101 ously.
SQLCII Sets tine squnehrhu levul. For Optmosu 102, 10.1, or 301 omnly.
SRCALC Selects inuternal or extennial lurvehi ung for tIne m nackinug gurmierator.
Opt iosm 010 or 01/ only.
SRCAT Attenunates the mmmc omitpuut luvel. Options 010 on 011 for h/nc
liP 8.59/A oss/y.
SRCNOR81 Sunlit mints trace B frounu trare A. nuuhuhs this’ slistslav hum’, amuuh
senuds the ressult to tmnuce n\.
SItC l~O1’S Olfset s t hue somirce isower Im’vel. Optiosu 01(1 on 011 csrs/y.
SRCPS’I’I’ Selects time sonnmce-luosver stehu size. Optioss 010 on 011 oruly.
SEC I
5SWP Selects sweep nanugs’ of suusu nce ouutpunt . Opbmo,u 010 msr 011 oun/uj.
SIIC PWIf Ss’ls’cts the sn,unmce lmuumvsrn level. Opt mm 010 on Oil ouuly.
S IICTK Auljui sts tracki mug of source ouu tpunt win hi spsrctrunnun-uunualyzem
sweep. Oplnosu 010 on 011 ors/y.
SRC’I’NPK Auljmnst s trankinug of souuncs’ uuunt Isut wit Ii slsect run mum auuMzurn
sweur
1u. Ojs/ ions 01(1 or 011 omuIy.
SWPCP L Selects a sti mmml uns-responuse ( SB ) or spectnunumi-ania lyzem ( SA
aim to-cons pl u’uI sweep Ii muse. Opt nmsmn 010 on Oil on/y.
BANDWIDTH (BW)
RB Specifies resohuntiomu hsnuniuhwiuhthu.
VAVO Tunnnus oum or off rushers uuveragu mg.
VII Specifies viuheo huannul wiult Ii.
VBR Specifies counpi i mug mnutics of viuleus bsanidwishtbi to nursol un thou
ha mu ul wi ml thu.
CALIBRATION (CAL)
CAL Inuitiates thur s~secified self.cnslihratiouu nountiuue.
C NP l
5erfommmis t huur conuIishemuce test
CO It liEN It et in rnisa” I’’ if tIne cnumrect iou Factors are on.
C RTIIP OS S pen his’s t hue sluect nun nun analyzer ul isjsl ay ‘in In on zontal lmosi tins.
CRTVPOS Sps’cibies tIne spent mmmii aumahyzer uhuslulnsy’s vu’rtical sosmt iuuuu.
Programming Commands 3-7