HP 8920B - Page 240

240
Common Command Descriptions
*SRE (Service Request Enable)
The Test Set responds to the *SRE command. "HP-IB Service Requests" on page
311
for a detailed explanation of the *SRE command.
*SRE? (Service Request Enable Query)
The Test Set responds to the *SRE? command. "HP-IB Service Requests" on page
311
for a detailed explanation of the *SRE? command.
*STB? (Status Byte Query)
The Test Set responds to the *STB? command. "Status Reporting" on page 260 for
a detailed explanation of the *STB? command.
*TRG (Trigger)
The *TRG command is equivalent to the IEEE 488.1 defined Group Execute
Trigger (GET) message and has the same effect as a GET when received by the
Test Set. The Test Set responds to the *TRG command by triggering all currently
active measurements.
*PCB (Pass Control Back)
The Test Set accepts the *PCB command. "Passing Control" on page 334 for a
detailed explanation of the *PCB command.