482
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
[] Connect
When lit, the Connect annunciator indicates that the mobile station is connected
to the Test Set on a voice channel.
The
Connect annunciator is not programmable.
The state of the
Connect annunciator is reflected in the Call Processing Status
Register Group Condition Register bit 5. See “Status Reporting” in the
Application Guide for further information.
NOTE: When the CALL CONTROL screen is displayed and the Call Processing Subsystem is in the
Connect state, the host firmware constantly monitors the mobile station’s transmitted
carrier power. If the power falls below 0.0005Watts the Test Set will terminate the call and
return to the Active state. The mobile station’s transmitted carrier power is monitored on
all Call Processing Subsystem screens except the ANALOG MEAS screen.
To Next Page
Loading...
