HP 8920B - Page 509

509
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
VC Order
This field is used to send an order type mobile station control message on the
forward voice channel to the Mobile Station with Authentication active. The VC
Order
field is only visible when authentication is activated and the mobile is
assigned a voice channel.
The orders available are:
• Change Power to Power Level 0 - 7
• Maintenance (put the mobile station in maintenance mode)
• Alert (alert the mobile station)
• SSD Update (shared secret data update)
• Uniq Ch (unique challenge)
The :VCORDer command is used to send an order type mobile station control
message to the mobile station. The Access annunciator will light momentarily
while the Test Set is sending the mobile station control message.
A mobile station must be actively connected on a voice channel to the Test Set
(that is, the
Connect annunciator is lit) before attempting to send an voice
channel order to a mobile station.
The query form of the command (that is, :VCORDer?) can be used to determine
the last order sent to the mobile station using the :VCORDer command.
Syntax
:VCORDer <’><order message><’>
:VCORDer?
Example
OUTPUT 714;"CALLP:AMPS:VCORD ’CHNG PL 0’"
OUTPUT 714;"CALLP:AMPS:VCORD?"
ENTER 714;Last_ord_sent$