522
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL DATA Screen
Display Word
This field is used to select the desired reverse control channel or reverse voice
channel message to be displayed.
The :DATA command is used to control this field.
The query form of the command (that is, :DATA?) can be used to determine
which reverse control channel or reverse voice channel message is currently being
displayed.
See "Reading the CALL DATA Screen Message Fields" on page 524 for information
on how to read the contents of the individual messages.
Syntax
:DATA <’><Reverse Control or Voice Channel message word><’>
:DATA?
Example
OUTPUT 714;"CALLP:AMPS:DATA ’RECCW A’"
OUTPUT 714;"CALLP:AMPS:DATA?"
ENTER 714;Message$
Handoff
See "Handoff" on page 495 for programming information.
Order
See "Order" on page 498 for programming information.
Page
See "Page" on page 500 for programming information.
To Next Page
Loading...
