68
Chapter 3, HP-IB Command Guidelines
Guidelines for Operation
Changing Display Units.
Use the DUNits command to change the units-of-
measure used by the Test Set to display any field setting or measurement result.
For example, to change the Display Units setting for the TX Power measurement
field from W to dBm, the following command would be used:
MEAS:RFR:POW:DUN DBM
Display Units DUNits Command Example
GHz :MEAS:RFR:FREQ:ABS:DUN GHZ
MHz :MEAS:RFR:FREQ:ABS:DUN MHZ
kHz :MEAS:RFR:FREQ:ABS:DUN KHZ
Hz :MEAS:RFR:FREQ:ABS:DUN HZ
ppm :MEAS:RFR:FREQ:ERR:DUN PPM
%D :MEAS:RFR:FREQ:ERR:DUN PCTDIFF
V :MEAS:RFR:POW:DUN V
mV :MEAS:RFR:POW:DUN MV
mV :RFG:AMPL:DUN UV
dBmV :RFG:AMPL:DUN DBUV
W :MEAS:RFR:POW:DUN W
mW :MEAS:RFR:POW:DUN MW
dBm :MEAS:RFR:POW:DUN DBM
db :MEAS:AFR:DISTN:DUN DB
% :MEAS:AFR:DISTN:DUN PCT
s :DEC:FGEN:GATE:DUN S
ms :DEC:FGEN:GATE:DUN MS
To Next Page
Loading...
