Reference 55
SCR Reference (man Pages)
scrfilter (1M) - Formats
search condition is reset.
The search condition affects the specified
group
only.
Whether other groups are displayed or not depends on
each view flag value of groups.
The
pattern
needs to be enclosed by round brackets.
Asterisk (*) can be used as wildcard character.
Backslash (\) is required as escape character to use
asterisk or round brackets as part of the
pattern
. The
pattern
is allowed to exist only one
attribute
per
each
group
. The attempt to set second
pattern
into
different
attribute
within one
group
is not allowed.
The option is prohibited for the collection filter Probe.
-u
filter
Update specified filter settings by accessing the
configuration data name available on managed nodes.
If new data is detected, the data name is imported to
the filter. The update option does not remove existing
data names. The view or collection flag value for the
new data is defined by the extension flag with the
exception that off is set merely on the highest data.
(See NOTE for more information.)
Formats
The filter name list generated by the scrfilter command without
options or with the -l option has the following format:
filter_name1
filter_name2
:
The filter settings list generated with the -l option specified has the
following format:
[Filter Name]:
filter
[Data Version]:
data_version
[Extension]:
flag
Component:
component1 fla
g
op
ti
on
Group:
group1 fla
g
op
ti
on
Attribute:
attribute1 fla
g
op
ti
on
To Next Page
Loading...
Need help?
General